Install Digital Controller and water supply hoses
7. Install Digital Controller Mount Digital Controller (71) on wall below bottom of counter top about 4"- 6" with three mounting screws (77).
8. Install water supply hoses For 1/2" shut off valve connector:Connect 3/8" x 1/2" adapter housing (85) (with pre-installed check valve 86 and strainer 87) to 1/2" cold water supply shut off valve (82). Note: Be sure to install check valve (86) and strainer (87) to prevent hot/cold water crossover flow.
For 3/8" shut off valve connector:
Connect the 3/8" x 1/2" adapter housing (85) (with pre-installed check valve 86 and strainer 87) onto 1/2" x 3/8" adapter (88) to 3/8" washer (89) then connect to 3/8" cold water shupply shut off valve (82). 9. Connect 3/8" cold water inlet supply hose (81) to 3/8" x 1/2" adapter housing (85).For hot water supply repeat step 7 and 8 using 3/8" hot water inlet supply hose (83). 10. Insert quick connector of 3/8" cold water supply hose (81) to cold water inlet nozzle on Digital Controller. Warning: The hose quick connector must be inserted completely to prevent hose from falling off Digital Controller. 11. With the same procedures to insert quick connector of 3/8" hot water supply hose (83) to hot water supply inlet nozzle (27) on Digital Controller.
12. Install spout outlet hose Connect 3/8" hose connector (23) to swivel connector (21) on Digital Controller.
13. Install spray hose weight (24) on spray head water hose (22) about 3" from the lowest bending point of hose.Then secure spray hose weight bolt (25) into spray hose weight (24). |
|